Alvey Surfcasting Reels – reliable, almost indestructible – New Stealth 65S

Alvey Surfcasting Reels – Bruce Alvey talks about the latest reels in the Alvey range including the new Stealth 65S

Video: Bruce Alvey, part of the family who has owned the Alvey company for 100 years talks through the latest reels plus all the features of the many reels on offer.

I own no fewer than five Alvey reels and would use no other for surfcasting. Their ruggedness and dependability in all conditions have to be experienced to be appreciated. They will keep going when other more complex reels have given up! On big fish, they really come into their own being almost indestructible.

Bruce Alvey at a demonstration day in Christchurch.

Alvey fishing reels have been made in Brisbane, Australia, since 1920. In Australia, they are immensely popular and have been for decades. Though almost an institution in Australia, they have never been a big seller in New Zealand.

There are several reasons for this. I feel the main one has probably been the price. Unfortunately, Alvey reels have always been quite expensive to purchase along­side thread-lines (eggbeaters). Surfcasters in New Zealand are more likely to own an eggbeater than any other type of fishing reel. However, these eggbeaters don’t hold up well on extra large fish. The centre shafts tend to bend if too much pressure is applied, and some models become quickly obsolescent. The Alvey side-cast reel is of very solid construction and has been designed to last.

Another reason many are put off buying an Alvey is that their rod is not fitted with a low mount reel seat. For most anglers buying a rod and reel together is a big financial outlay. Most will own rods with the reel seat too far up the rod for the outfit to balance properly. It is possible, in most instances, to fit a second lower mount reel seat to an existing surf rod with a little modification.

Alvey’s John McConky from Australia with one of the stainless steel backed models. Note John is not wearing a rod bucket.

The first-rod guide on rods set up for an Alvey reels should be about halfway up the rod and it also should be at least two inches in diameter. So although these minor changes can easily be made I believe that not having the right rod set up is another reason most Kiwi anglers have not selected and Alvey.

Another reason for sluggish sales is that Alvey reels have not been generally available. Instead, they have been sold by only a few specialist shops.

Finally, I suspect that many New Zealand fishermen are unaware of the considerable practical advantages of the Alvey fishing reel system.

A few years back Australians Bruce Alvey and John McConkey toured New Zealand and gave 16 free Alvey seminars and casting demonstrations. These were attended by some 750 interested anglers and went some way to educate on the advantages of Alveys.

It was very interesting to note that many anglers who had never cast with this type of reel before were able to achieve considerable distances straight away. Casting seems a bit strange at the beginning but the system is one of the easiest of all to master.

I believe the most important thing to remember when casting and retrieving is to avoid loose coils on the reel. Always take the slack up with your other hand before you begin winding the handle. This is important because loose coils trap the line beneath them causing bust-offs and tangles. This business of taking up the slack line becomes second nature after a while. It takes only a second and you don’t even realize that you are doing it!

You can see the different rod set-ups here. The Alvey needs the winch fitting close to the rod butt for good balance.

For most right-handed anglers the line is released from the reel with the left hand. Again this is a bit odd, to begin with, but don’t worry you soon get used to it.

With an Alvey, because there is almost no resistance to the line as the coils drop from the reel, a much wider range of cast weights can be used. Starting from no lead at all – just the bait, up to as much as the rod is designed to cast. This is a big advantage because you can, depending on the situation, easily cast a whole un-weighted pilchard.

An Alvey reel is relatively heavy com­pared with other reels – notwith­standing that Alvey is now pro­ducing some excellent lighter weight graph­ite models. The reel is also quite bulky, particularly in the larger sizes. The larger sizes are better, in my view, because they retrieve more line for each wind of the handle.

This extra weight and bulk mean that the reel must be fished down towards the bottom of your rod for proper balance. I am sometimes asked if it is possible to fish with a side-cast reel positioned higher up the rod so that you don’t need a special rod for use with this reel. The answer is yes you can fish an Alvey reel with your normal high-mount surfcasting rod, but you have to make a couple of modifications.

Firstly, you have to add a second reel mount to the rod about eight inches (200mm) from the butt. This measurement includes you wooden butt spike. This modification is quite simple to ef­fect. The new reel seat is slid on from the bottom and up over packing formed from masking tape. The idea is to make this a good tight fit.

The Alvey reel turned 90 degrees to the casting position. The line is held with the thumb until the moment of release. This particular Alvey reel model 650GRC is unusual in that it is geared with a ratio of 2.5:1, In other words, the spool turns two and a half times for each turn of the handle.

Packing “rings” of masking tape should be spaced along where the reel seat will be glued. At least one toward the top, another near the bottom, and at least one in the middle. Don’t wrap tape all the way under the seat because you need some space for the two-part epoxy glue to form a bond between the rod blank and the inside of the reel seat.

 The second modification is to enlarge the first line guide. If the rod was originally set up for use with an eggbeater (fixed spool reel) it will quite possibly be OK to use as it is. What you are ideally looking for is the first line guide to be at least two inches (5Omm) in diameter, and be approximately halfway up the rod. If you can only just fit your finger through the first (biggest) line guide, then it is far too small. Your tackle store will be able to sell you a bigger one no problem. Try to get one that matches the others. If it doesn’t, it doesn’t matter. It just means it looks a bit odd! The fish won’t be able to tell the difference!

A good tackle store will be happy to fit a second reel seat and a bigger line guide to your rod for a modest charge if you are uncertain about doing it yourself. If they aren’t willing, go somewhere else. The cost of these modifications should be around forty dollars.

Now you have turned your twelve foot, or so, long surfcaster into a dual purpose high and low mount rod. This may not be ideal. It depends on what sort of blank, line guides, and guide positioning you had in the first place. I used a rod adapted in this way for many years before I could afford a top of the line, purpose-built model. It may have looked a bit strange but I caught many hundreds of fish with it, and still have it!

Trying an Alvey reel for the first time under expert guidance. Most were surprised at just how easy the outfit was to cast!

With this setup, you will be able to start fishing with your new Alvey side caster with­out the expense of having to purchase a rod and reel all in one go.

Rod Buckets for Alvey Reels

The weight of the Alvey reel is all at the bottom of your rod. This means that you must have a rod bucket or pouch to fit the butt of your rod as you can see from the picture. Alvey makes a range of rod buckets for just this purpose. You can, if you wish, cut a bit of the plastic from a boat fishing rod bucket as I have done and use this. The pin stops the rod falling out.

You need a rod bucket to balance your outfit and make winding in your line quick and easy. Fishing an Alvey is hard work without the rod bucket, so get yourself one at the outset.

A short history of Alvey Australia Fishing Reels.

Alvey Saltwater Fly Reel Reviewed by Allan Burgess

Alvey 650 GRC High-Speed Spinning and Surfcasting Reel

Alvey Reels Australia

Alvey Reels Saved April 2018

Some of the author’s Alvey side cast reels. From left: 650C, 650GRC, 600C5, and 55C5.

Here is a quick look at the unusual geared Alvey 650GRC side caster.

This post was last modified on 14/08/2021 11:44 am

Leave a Comment
Published by

Recent Posts

The Big Fish Edition – How to Catch Fish and Where

The Big Fish Edition - How to Catch Fish and Where - The Complete Kiwi…


How to Catch Fish and Where

How to Catch Fish and Where - The Complete Kiwi Beginner's Guide By Mike Rendle…


Fishes of Aotearoa by Paul Caiger

Fishes of Aotearoa (includes both fresh and saltwater fishes) By Paul Caiger New Zealand has…


Fishing the Tongariro – A History of Our Greatest Trout River

Fishing the Tongariro - A History of Our Greatest Trout River By Grant Henderson  Since…


Porare – Girella tricuspidata

Porare - Girella tricuspidata - How and Where to Catch Porare By Allan Burgess Although…


Jack’s Sprat Trout Fly

Jack's Sprat Trout Fly - An old favourite for targeting rainbow trout in the lakes…