How-to Advice and Fishing Tips for Anglers

High Sticking – How Fishing Rods Get Accidentally Broken

It can be a very depressing end to a fishing trip when you arrive back at your car and are just about to head home and accidentally shut your best pride and joy fishing rod in your car door. In all my years of fishing, I have only ever broken one rod and that is how it happened. However, as the father of three boys, they have managed to snap several more by swishing them around inside the house. High Sticking is one “accident” you can easily avoid.
Rods also get broken when you overload your car without first placing them in crush-proof PVC tubes.
I remember many years ago surfcasting on the West Coast with a group of anglers. We all decided to load our gear into the vehicles and head a few kms further down the beach. There were a dozen of us altogether. We just crabbed our gear as quickly as possible and loaded up for the short journey to what we hoped would be a better spot further along the beach.
One of the members of our party insisted on completely dissaembling his rod, placing each section carefully into a cloth bag, and then sliding the cloth bag into his PVC tube while the rest of use waited impatiently. Looking back I can see he wasn’t silly at all. I bet none of his rods ever got broken.

Here are a few dangers to be on your guard against

1. High Sticking sounds right. I’ve seen that happen a couple of times to people.
2. A big rod killer is shutting it in your car door in the dark or chopping the tip off when you wind the window up. I’m guilty of that one.
3. A fly rod smasher is the old poorly cast hare and copper bomb scoring a direct hit.
4. And, funny when it happens to someone else is your surfcasting rod reverting to a two piece mid-cast as the top section of your three piece rod gets cast out as well as your sinker and hooks. With a bit of luck you can wind the tip section back in.

From Kilwell Sports about how to avoid High Sticking

High Sticking – A rod’s power is in the butt, not the tip.
Kilwell don’t just sell fishing rods, they make them, including the blanks, in their Rotorua factory.
Proper rod angle during the fight is important, more so when fighting big fish from a boat. Make your rod work for you. A good fisherman with good technique and a good understanding of a rod’s dynamics will keep the rod tip below 45 degrees, keep constant pressure on the fish, do not give the fish a chance to rest. If you can put 10 pounds of pressure on a fish and keep it there, you can beat any fish. www.fishing.kilwell.co.nz

This post was last modified on 04/02/2022 7:07 pm

Share
Leave a Comment
Published by

Recent Posts

The Big Fish Edition – How to Catch Fish and Where

The Big Fish Edition - How to Catch Fish and Where - The Complete Kiwi…

20/07/2024

How to Catch Fish and Where

How to Catch Fish and Where - The Complete Kiwi Beginner's Guide By Mike Rendle…

12/07/2024

Fishes of Aotearoa by Paul Caiger

Fishes of Aotearoa (includes both fresh and saltwater fishes) By Paul Caiger New Zealand has…

03/07/2024

Fishing the Tongariro – A History of Our Greatest Trout River

Fishing the Tongariro - A History of Our Greatest Trout River By Grant Henderson  Since…

03/07/2024

Porare – Girella tricuspidata

Porare - Girella tricuspidata - How and Where to Catch Porare By Allan Burgess Although…

18/06/2024

Jack’s Sprat Trout Fly

Jack's Sprat Trout Fly - An old favourite for targeting rainbow trout in the lakes…

21/05/2024